Fenix LD22 Flashlight
The Fenix Model LD22 provides reliable illumination in a wide variety of applications. With four brightness levels and two flashing modes, LD22 employs a side mode switch for quick changes. Powered by readily-available AA batteries, this compact flashlight showcases the durability and power management for which Fenix is recognized around the world. Technical Parameters
General Mode ANSI/FSC DISTANCE INTENSITY RESISTANT WATERPROOF ACCESSORIES
Holster, body clip, lanyard and spare o-ring
Cree XP-G (R5) LED with a lifespan of 50,000 hours Uses two 1.5V AA (Ni-MH, Alkaline ) batteries 156mm (Length) x 21.5mm (Diameter) 60-gram weight (excluding batteries and body clip) Digitally regulated output maintains constant brightness Reverse polarity protection guards against improper battery installation Anti-roll, slip-resistant body design Push-button tail cap switch with momentary-on function Side mode switch in the front, fast and convenient Made of durable aircraft-grade aluminum Premium Type III hard-anodized anti-abrasive finish Toughened ultra-clear glass lens with anti-reflective coating
Notice: The above-mentioned parameters (lab-tested with 2500mAh Lithium battery) are approximate and may vary between flashlights, batteries and environments. Operation Instruction Turning on/off Press the tail cap switch lightly to momentarily activate the flashlight. Press the tail cap switch completely to turn on the flashlight and lock it. Another press will turn it off. Mode selection A single press on the side mode switch allows switching between Turbo Low Mid High brightness levels; Press and hold the side mode switch for about one second to enter into Strobe mode. Press and hold the side mode switch for about three seconds to enter into SOS mode. While in Strobe or SOS mode, a single press on the side mode switch returns you to the non-flashing mode. LD22 memorizes the brightness level while in the general mode. When turned off and then on, the flashlight automatically enters the general (non-flashing) mode. Battery Specifications
Dimensions Nominal voltage Usability
Recommended √
Warning: please do not mix o using batteries of other manufacture, capacity, size or type. Doing so will cause damages to the batteries or flashlights. Notice: When use 2 fresh alkaline batteries, maybe due to the high voltage, the brightness of the Low level will be close to that of the Mid in the early stage. However, after working some time, the brightness of the Low will perform normally.
Battery Replacement Unscrew the tail cap to put in the battery with the anode side (+) toward the light head. Simply screw the tail cap back on to test. Usage and Maintenance
Please don't disassemble the sealed head as doing so can cause damage to the flashlight and
To get the most from this LD22, Fenix recommends using high-performance Ni-MH
rechargeable batteries. Alkaline batteries will reduce runtimes significantly.
High-quality batteries are essential and must be removed when the flashlight will not be used
for an extended period of time. As with other performance electronics, LD22 can be damaged by battery leakage and the potential for battery explosion.
Due to the momentary-on tactical switch, the flashlight can be activated when stored,
transported or placed in a pocket. Unscrew the tail cap one-half turn to avoid unwanted operation.
Long-term use can result in O-ring wear. To maintain a proper water seal, replace the ring
Periodic cleaning of the battery contacts improves the flashlight’s performance as dirty
contacts may cause the LD22 to flicker, shine intermittently or even fail to illuminate for the following reasons: Reason A: The battery needs replacing. Solution: Replace batteries (Please confirm the correct installation of anode and cathode). Reason B: The threads, PCB board contact or other contacts are dirty. Solution: Clean the contact points with a cotton swab soaked in rubbing alcohol. If the above methods don't work, please refer to the warranty policy before contacting your authorized distributor. Product Warranty We will replace products with documented manufacturing defects within 15 days of purchase and repair a light free of charge within 24 months of purchase if problems develop with normal use; if repair is required after 24 months from the date of purchase, we will charge for parts. The total repair fee is dictated by the cost of the replaced materials. Warranty Card Registration We kindly suggest that you register your guarantee card on the official website of Fenixlight Limited. You’ll receive an extra six months of warranty coverage once you have successfully registered. By participating in an optional customer survey, you are entered in a drawing for free Fenix products. Warning LD22 is a high-intensity lighting device and capable of causing eye damage to the user or others so please avoid shining the light directly into anyone’s eyes.
FRASER AND NEAVE, LIMITED (UEN/Company Registration No. 189800001R) (Incorporated in the Republic of Singapore) ANNOUNCEMENT S$150,000,000 3.62 per cent. Notes due 2015 comprised in Series 003 (ISIN: SG7E40927117) (the “F&N Notes”) issued by Fraser and Neave, Limited (the “Company”) pursuant to its S$1,000,000,000 Medium Term Note Programme (the “F&N Progr
Web of Lies: How to protect yourself on the Infohighway The New York City Department of Consumer Affairs The Internet is becoming a big part of our everyday lives. But there are nogatekeepers on the “information superhighway.” New, unregulated technology means new opportunities for consumers, investors, yourself The rise of Internet use brings more deceptive and misleading promotions,
Fenix LD22 Flashlight